Question: We have a breaker that keeps popping-we have had it replaced once but the guy said the board was too small-barely met code, which he said is not unusual in homes. He quoted a huge amount to upgrade, what is a ballpark figure of what it should cost to replace?
Answer: If you are talking about upgrading your service, you will be looking at between $1,000 and $1,750 plus any utility fees (usually about $500) and the cost of a permit.
------------------------
- LED/Incandescent Christmas Tree Lights
- Wiring An Electric Hot Water Tank
- High & Low Voltage Cables
- Flatwire
- Two Wires On A Breaker
- Grounding Rods & Standby Generators
- Fuse Panel Replacement
- Fuse Keeps Blowing
- Identifying Electrical Circuits
- Noisy Dimmer Switch
- Broken Bulb Socket
- CAT-5 Plenum versus Standard Cable
- Dead Batteries In Smoke Detectors
- Garbage Disposal Switches
- Painting Outdoor Breaker Panels & Meters
- How Does Smart Electrical Meter Work?
- Preventing Power Failure
- Intermittent Electrical Receptacles
- Flickering Lights
- Wiring a Light
- Changing Fuses to Beakers
- Breaker Tripping - Light Switch Is Turned On?
- 12/2 Wire On A 15 Amp Breaker
- Fuse To Circuit Panel Upgrade
- Upgrading An Electrical Service
- Change Circuit Breaker Or Split Power?
- Faulty Ceiling Fan Remote Control